35
4. Disconnect connectors from the timer.
The number of connectors will vary
depending on the number of ovens and
features available.
5. Remove four screws and the digital timer
from the control panel assembly.
6. Remove two screws and mounting bracket
from each side of the timer.
7. Reverse procedure for installation.
Analog Timer
WARNING: Disconnect power to oven
before servicing. Follow lockout/tagout
procedures.
CAUTION: Some areas of the oven
interior are sharp; wear protective gloves to
avoid injury.
Condition Requirements:
Partial Access to Control Components
1. Pull to remove one knob from the analog
timer.
NOTE
Follow steps 2 through 6 of the digital timer
removal. The analog timer will look slightly
different; however the procedure is the same.
2. Reverse procedure for installation.
To Next Page
Loading...
