43
Door Hinge Receiver Removal
CAUTION: Some areas of the oven
interior are sharp; wear protective gloves to
avoid injury.
Condition Requirements:
Oven Fully Removed
1. Remove seven screws that hold the side
panel to the oven.
2. Carefully pull back the side insulation
from the front edge of the oven to reveal
the hinge receiver.
3. Remove two screws that attach the hinge
receiver to the oven frame.
NOTE
It is important to return insulation back to original
position. Replace any insulation that is missing or
destroyed.
4. Reverse procedure for installation.
Meat Probe Socket Removal
CAUTION: Some areas of the oven
interior are sharp; wear protective gloves to
avoid injury.
Condition Requirements:
Oven Fully Removed
1. Remove seven screws that hold the side
panel to the oven.
2. Carefully pull back the side insulation
from the front top edge of the oven to
reveal the meat probe socket.
3. Disconnect two connectors from the meat
probe socket.
4. Lift the meat probe jack cover and remove
the 5/8 inch nut that attaches the jack to
the oven liner.
NOTE
It is important to return insulation back to original
position. Replace any insulation that is missing or
destroyed.
5. Reverse procedure for installation.
To Next Page
