To Next PageTo Next PageWhy does the broil not work on my Viking VDSC536 Ranges?
If the broil function isn't working on your Viking Ranges, the temperature control knob may be rotated too far past the broil position. Adjust the temperature control knob back to the broil position.
Why are the igniters sparking continuously after flame ignition on my Viking VDSC536 Ranges?
If the igniters on your Viking Ranges are sparking continuously after the flame ignites, the power supply may not be grounded, the power supply polarity may be reversed, or the igniters may be wet or dirty. Ground the power supply, correct the power supply polarity, or clean the igniters.
Why is the flame large, distorted, or yellow on my Viking Ranges?
If the burner ignites but the flame is large, distorted, or yellow on your Viking Ranges, it could be due to clogged burner ports, using the wrong type of gas, or improperly adjusted air shutters. Try cleaning the burner ports, using the correct type of gas, or adjusting the air shutters properly.
What to do if the oven light will not work on my Viking VDSC536?
If the oven light in your Viking Ranges isn't working, it could be due to a burned-out bulb or a power issue. Try replacing the bulb first. If that doesn't work, check the power connection to the range.
What to do if the door won't open on my Viking Ranges?
If the door of your Viking Ranges won't open, the oven may still be in self-clean mode. Wait for the oven to cool down completely. The door latch will release automatically once a safe temperature is reached.
Why is the burner flame large and yellow on my Viking VDSC536 Ranges?
If the burner flame on your Viking Ranges is large, distorted, or yellow, it could be due to several factors. Check if the burner ports are clogged and clean them if necessary. Ensure that you are using the correct type of gas for the unit. Also, the air shutters may need adjustment.
What to do if the door will not open on my Viking VDSC536 Ranges?
If the door of your Viking Ranges will not open, it might be because the oven is still in self-clean mode. Wait until the oven cools down; the door latch will release once a safe temperature is reached.
Why are the igniters sparking but no flame ignition in my Viking VDSC536?
If the igniters on your Viking Ranges are sparking but not igniting the flame, check whether the gas supply valve is in the “OFF” position and turn it to “ON”. Also, check if the gas supply is interrupted.
Covers general and specific information for Viking Dual Fuel Ranges.
Explains safety alert symbols and hazard definitions for user safety.
Details the warranty coverage for Viking Professional Series Dual Fuel Ranges.
Technical specifications including ratings, clearances, and dimensions.
Specifications for electrical and gas connections.
Checks to be performed by an installer after installation.
Explains LED error codes and DSI board fault codes for diagnostics.
Troubleshooting common oven component failures with corrective actions.
Step-by-step guides for checking convection, bake, and broil element operation.
Diagnostic steps for griddle operation and spark module testing.
Information on RTD sensor testing and specifications.
Steps to access and remove the main control board assembly.
Procedures for removing door assembly, gasket, handle, and glass.
Procedures for removing door hinges and the oven temperature sensor.
Procedures for removing the bake element and rack supports.
Steps to remove the convection fan cover and assembly.
Procedures for removing bake/broil elements and control panel.
Procedures for removing oven thermostat and function selector.
Procedures for removing oven light bulb and switch.
Procedures for removing indicator lights and door lock assembly.
Procedures for removing IRIS module and griddle components.
Procedures for removing direct spark module and burner valve.
Procedures for removing island trim and backguard assembly.
Procedures for removing the main top and jet holder.
Procedures for removing manifold assembly and pressure regulator.
Procedures for removing burner base assembly and side panels.
Procedures for removing blower motor and back panel.
Procedure for removing the terminal block.
Detailed wiring diagram of the oven control board.
Wiring diagrams for specific heating elements.
Wiring diagrams for convection, blower, and door latch motors.
Wiring diagrams for electronic thermostat and griddle systems.
Wiring diagrams for VDSC530, VDSC536, and VDSC548 Dual Fuel Ranges.
General| Width | 36 inches |
|---|---|
| Oven Capacity | 5.0 cu. ft. |
| Number of Burners | 6 |
| Convection | Yes |
| Finish | Stainless Steel |
| Material | Stainless Steel |
| Dimensions (WxDxH) | 36 x 28 x 36 inches |
| Type | Freestanding |
| Ignition Type | Electronic |
| Gas Type | Natural Gas or LP |
| Burners | 6 sealed burners |
