Vimar SW230.T - Programming and Deleting the Remote Control

9. Programming and deleting the remote control.
The maximum storage capacity is 128 remote controls.
Caution: The remote controls can only be saved and deleted when the gate is stationary.
Programming the button of the remote control associated with input SEQ.
1. Press push button P2 and hold it down until LED DL7 (PRG) starts to ash (1
st
ashing frequency).
2. Release push button P2.
3. Within 10 seconds, activate the radio control button to be learnt and associated with the sequential or start control.
4. Learning procedure completion will be signalled by the ashing of the ashing lamp, followed by the LED DL7 that stops ashing.
5. Repeat the process for every radio control to be learnt.
Programming the button of the remote control associated with input PED.
1. Press push button P2 and hold it down. LED DL7 starts to ash (1
st
ashing frequency).
2. Do not release push button P2 until it ashes faster (2
nd
ashing frequency).
3. Release push button P2.
4. Within 10 seconds, activate the radio control button to be learnt and associated with the pedestrian control.
5. Learning procedure completion will be signalled by the ashing of the ashing lamp, followed by the LED DL7 that stops ashing.
6. Repeat the process for every radio control to be learnt.
Programming the button of the remote control associated with output +P.OUT for the 2
nd
radio channel (Dip switch 10 must be OFF).
1. Press push button P2 and hold it down. LED DL7 starts to ash (1
st
ashing frequency).
2. Do not release push button P2. The ashing becomes faster (2
nd
ashing sequence).
3. Do not release push button P2 until it ashes faster (3
nd
ashing frequency).
4. Release push button P2.
5. Within 10 seconds, activate the radio control button to be learnt and associated with the +P.OUT control.
6. Learning procedure completion will be signalled by the ashing of the ashing lamp, followed by the LED DL7 that stops ashing.
7. Repeat the process for every radio control to be learnt.
Deleting a single remote control saved.
1. Press push button P2 and hold it down. LED DL7 starts to ash (1
st
ashing frequency).
2. Do not release push button P2. The ashing becomes faster (2
nd
ashing sequence).
3. Do not release push button P2. The ashing becomes faster (3
nd
ashing sequence).
4. Do not release push button P2 until it ashes faster (4
nd
ashing frequency).
5. Release push button P2.
6. Within 10 seconds, activate the button of the remote control to be deleted.
7. Learning procedure completion will be signalled by one ash of the ashing lamp, followed by the LED DL7 that stops ashing.
Deleting all the saved remote controls.
1. Disconnect the power supply to the control unit.
2. Reconnect the power supply to the control unit by holding down push button P2.
3. Wait for the DL7 LED to stop ashing.
4. At the end of this procedure, all the remote controls in memory are deleted.
29
SW230.T / SW230.T.120
EN