VIPA System 300S SPEED7 CPU 313SC/DPM - Page 84

Chapter 4 Deployment CPU 313SC/DPM Manual VIPA System 300S SPEED7
4-44 HB140E - CPU SC - RE_313-6CF03 - Rev. 07/45
... continue
Event-ID Description
0xEA11 SBUS: Output address outside output area
Zinfo1: I/O address
Zinfo2: Slot
Zinfo3: Data width
0xEA12 SBUS: Error at writing record set
Zinfo1: Slot
Zinfo2: Record set number
Zinfo3: Record set length
0xEA14 SBUS: Multiple parameterization of a I/O address (Diagnostic address)
Zinfo1: I/O address
Zinfo2: Slot
Zinfo3: Data width
0xEA15 Internal error - Please contact the VIPA-Hotline!
0xEA18 SBUS: Error at mapping of the master I/O devices
Zinfo2: Master slot
0xEA19 Internal error - Please contact the VIPA-Hotline!
0xEA20 Error - RS485 interface is not set to Profibus DP master but there is a Profibus DP
master configured.
0xEA21 Error - Project engineering RS485 interface X2/X3:
Profibus DP master is configured but missing
Zinfo2: Interface x
0xEA22 Error - RS485 interface X2 - value is out of range
Zinfo: Configured value X2
0xEA23 Error - RS485 interface X3 - value is out of range
Zinfo: Configured value X3
0xEA24 Error - Project engineering RS485 interface X2/X3:
Interface/Protocol is missing, the default settings are used.
Zinfo2: Configured value X2
Zinfo2: Configured value X3
0xEA30 Internal error – Please contact the VIPA-Hotline!
0xEA98 Timeout at waiting for reboot of a SBUS module (Server)
0xEA99 Error at file reading via SBUS
0xEE00 Internal error - Please contact the VIPA-Hotline!