Why the motors do not work and no warning light turns on in my Viper Floor Machine?
If the motors on your Viper Floor Machine aren't working and no warning light is on, it could be due to a disconnected battery connector. In this case, connect the battery connector. Alternatively, the batteries might be completely discharged, so ensure you charge the batteries.
Why are the 3 battery charge indicators flashing simultaneously on my Viper AS4325B?
If the 3 battery charge indicators are flashing simultaneously on your Viper Floor Machine, it could indicate a brush motor overload. Try using less aggressive brushes. Alternatively, there might be foreign materials, like tangled threads, preventing the brush from rotating. Clean the brush hub to remove any obstructions.
General| Brand | Viper |
|---|---|
| Model | AS4325B |
| Category | Floor Machine |
| Language | English |
Explains the manual's purpose, content, and how to use it.
Details suitable environments and uses for the scrubber.
Location of serial number and model name for reference.
Explains safety symbols displayed directly on the machine.
Explains safety symbols used within the instruction manual.
Provides critical warnings and important cautions for safe operation.
Details the physical components and layout of the machine.
Identifies and explains the functions of the control panel.
Provides the physical dimensions of the machine.
Lists detailed technical specifications and performance data.
Illustrates the electrical wiring of the machine.
Instructions for installing and setting new batteries for the machine.
Step-by-step guide for charging the machine's batteries.
Steps to safely start and stop the machine for operation.
Procedures for operating the machine during the cleaning process.
Instructions for fitting and removing brushes or pad-holders.
Guidance on how to properly clean brushes and pads.
Instructions for fitting and removing the squeegee assembly.
Procedures for cleaning the squeegee for optimal performance.
How to inspect and replace squeegee blades.
Procedures for filling the solution and water tanks.
Steps for draining the recovery and solution tanks.
Guidance on how to clean the solution filter.
Cleaning tank components and checking seals.
Essential steps to perform after finishing work.
Instructions for storing the machine for extended periods.
Checks required after the initial 8 hours of operation.
Table outlining maintenance tasks and their frequency.
How to charge the batteries using the installed onboard charger.
Lists common problems and their corresponding solutions.
Guidance on the proper disposal of the machine.
To Next Page
