69
Viscount Concerto III - Operating Manual
9. [ORCHESTRA SECTION] buttons (version with Orchestra voices only): this section contains
the organ’s Orchestra voices. One of the key features of the Concerto III is the provision of these
voices, allowing you to play all the instruments covered by the General MIDI standard, enhancing
your organ’s voice range.
The buttons are subdivided into four sections:
o [MAN. III]: third manual voices.
o [MAN. II]: second manual voices.
o [MAN. I]: first manual voices.
o [PEDAL]: pedal board voices.
each of them containing four preset voices (indicated above the selection button) plus one
which can be freely selected (CUSTOM). The button LED will come on to confirm that the
voice has been activated.
SELECTING THE CUSTOM VOICE
To select the Custom voice from the 128 available in the GM standard, keep the [CUSTOM]
button of the section of choice pressed for a few moments; the first video page for selecting the
group of instructions will appear:
use the cursor keys ([LEFT], [RIGHT], [UP] and [DOWN] underneath the display) to select the
group you require and press [ENTER/YES]; the eight voices in the selected group will be
displayed:
use the cursor keys again and then press [ENTER/YES] to activate the voice.
10. Display function control panel: see chap. 3 for a detailed description of this section.
11. [MIDI TO] LED: these LEDs provide information about the MIDI status for each manual and
the pedal board, as follows:
o [MIDI TO PEDAL]: pedal board MIDI.
o [MIDI TO MAN. II]: second manual MIDI.
o [MIDI TO MAN. III]: third manual MIDI.
o [MIDI TO MAN. I]: first manual MIDI.
Only when the LED is lightning, the section can transmit MIDI messages.
To set these parameters, recall the MIDI TO display function described in point 6.3.
To Next Page
Loading...
