Visonic PowerMax Complete - Reporting and SMS Control; Reporting to Private Telephone Numbers; Remote Control via SMS

SPECIAL FUNCTIONS
20 D-302755 PowerMaxComplete User's Guide
Important! If you wish to exit the two-way
communication mode and execute another
command, just press [  ] and then key your user
code followed by the command (see “keying
sequences” in Executable Commands table above).
Reporting to Private Telephone
control
panel
The PowerMaxComplete can be programmed by the
installer for selective transmission of messages to
private telephone subscribers. Messages are divided
by type into 4 groups:
Group
Events Reported
1
Fire (*), Burglary (**), Panic, Tamper
2
Arming AWAY, Arming HOME, Disarming
3
No-activity, Emergency (***), Latchkey,
Gas, Flood, Temperature
4
Low-battery AC failure
Note: In control panel with no-voice option, the
following siren signal will be sent to private telephone
upon event reporting:
* FIRE: ON - ON - ON - pause.... (- - - - - - ......).
** BURGLAR: ON continuously ( ...)
*** EMERGENCY: 2-tone siren; like an ambulance.
When the called party answers a call initiated by the
PowerMaxComplete, he will hear a verbal message
composed of the “house identity” and the type of
event that occurred. For example, once smoke is
detected in the Smith residence, the message will
be: [The Smith Residence - Fire Alarm].
If a person under surveillance in the Watkins
residence has been inactive, the message will be:
[The Watkins Residence - No Activity].
The called party must acknowledge the message (as
explained later on), but if he does not respond, the
message will be transmitted repeatedly as many
times as possible within a 45-second time limit.
When the 45 seconds are up, the
PowerMaxComplete will disengage the line and call
the next private telephone number on its list.
The called party can acknowledge the message by
pressing a key on the telephone keypad, as follows.
Command
Key
Acknowledge only: The
PowerMaxComplete disengages the
line and considers the event duly
reported.
2
Command
Key
Acknowledge and listen-in: The
protected site is “bugged” for sound for
50 seconds. The called party may
prolong the listening session by
pressing [3] again before the
PowerMaxComplete disengages the
line, or by pressing [1] to speak.
3
Acknowledge and speak out: The
called party may speak for 50 seconds
to whoever is in the protected site. The
called party may prolong the “speak
out” session by pressing [1] again
before the PowerMaxComplete
disengages the line, or by pressing [3]
to listen.
1
Acknowledge and 2-way conversation:
You and the called party can speak and
listen without any necessity to switch the
system from "listen-in" to "speak-out"
and vice versa for 50 sec. (extendable).
6
Acknowledge and request a status
report: The PowerMaxComplete will
issue a verbal report of system status.
For example:
[Disarm - ready to arm] or
[Disarm - back door open] or
[Disarm - alarm in memory].
9
Remote Control by SMS
PowerMaxComplete system with an optional internal
GSM unit can respond to SMS commands from any
cellular GSM telephone, only if the “REM ACCESS
ON” command was pre-selected by the system
installer.
The various SMS commands are detailed in the
following table (the detailed SMS message sending
process is described in the cellular telephone user’s
guide). In this table, “<code>” means 4-digit user
code and blank space simply means blank space.
SMS Command List
In the following table, "P#" is used only for
PowerMaxComplete with partition enabled - use P1,
P2, P3, or P4, according to the partition number.