USER SETTINGS
D-302755 PowerMaxComplete User's Guide 23
7. User Settings
What are the Settings You Need?
The installer provides you a ready-to-use alarm
system, but a few settings and adjustments will still
be needed.
Note: Although the user settings are your
responsibility, you may request your installer to
perform them for you (except for the user codes,
which you would like to keep secret).
The user settings include (if enabled by the installer):
Bypassing zones - determining which zones
will be bypassed (disabled) during the present
disarm period and the next armed period.
Reviewing the bypass list - "show bypass" -
displaying the numbers and names of bypassed
zone one by one.
Recalling the last bypassing scheme** -
"recall bypass" - re-using the previous bypassing
scheme, which becomes suspended after
disarming but is still saved in the
PowerMaxComplete memory.
Note: RECALL BYPASS is applicable when
partition is disabled.
Private report* - determining the event groups
to be reported to private telephone subscribers.
Determining the 1
st
, 2
nd
, 3
rd
and 4
th
telephone
numbers to which the system will report event
messages that were defined by the system
installer. Determining the number of times the
called party's private telephone number is
dialed. Determining whether or not 2-way voice
communication with private telephones will be
allowed. Determining whether to use a single
acknowledge signal, or, an acknowledge signal
from each telephone before the current event is
considered reported. Determining the 1
st
, 2
nd
, 3
rd
and 4
th
SMS telephone numbers to which pre-
selected event types will be reported.
Setting user codes* - programming a security
code for yourself and additional 7 codes for
other system users. Codes 5 through 8 are
“Latchkey” user codes (see Chapter 2 - Arming
in the Latchkey Mode for additional details).
Enrolling keyfob transmitters* - teaching the
PowerMaxComplete system to recognize the ID
code of each keyfob transmitter (multi-button,
Code-Secure™ type, wireless transmitter), so
that the PowerMaxComplete can respond to
commands transmitted by them.
Enrolling proximity tags - Teaching the
PowerMaxComplete to recognize the ID of each
proximity tag so that the PowerMaxComplete
can respond to proximity tags presentation.
Setting voice options* (not applicable in
PowerMaxComplete that does not have VOICE
feature) - Enabling or disabling verbal
announcements (prompts).
Auto arm option* - enabling or disabling
automatic arming (at a predefined time).
Setting auto arm time - selecting automatic
arming time.
Using squawk option* - enabling/disabling
LOW/MID/HI squawk (short siren sound) upon
arming and disarming. All the options are
applicable for wireless siren. For wired siren, refer
to LOW, MID and HI options as "squawk enable".
Setting the time and time format* - adjusting
the built-in clock to show the correct time and
time format.
Setting the date and date format* - adjusting
the built-in calendar date and date format.
Setting the scheduler* - setting schedule for
devices start/stop activation.
* This option can be accessed only if master user
code has been entered.
** This menu is not available when Partition is
enabled.
Entering the User Settings Menu
Figure 7 describes how to enter User Settings menu
(when all zones/partitions are secured).
Click the keys that you are instructed to press. The
resultant display is shown below each instruction
To Next Page
Loading...
