USER SETTINGS
D-302755 PowerMaxComplete User's Guide 31
You may now select any other item on USERS
SETTINGS menu or quit programming process by
clicking . When "<OK> TO EXIT" is
displayed, click .
Setting Arming Time
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button (repeatedly, if necessary) until
the display will read:
From here, proceed as follows:
[time
digits] (e.g.
12:55 A)
Notes:
1. For 12h/24h time format selection, refer to
Setting Time and Time Format below.
2. Press "" to enter A (AM), or press "#" to enter P
(PM).
Enabling the Squawk Option
You can determine that the system will activate (or
not activate) high/mid/low wireless siren sound, for a
short time, upon arming (1 beep) and disarming (2
beeps), by keyfob only.
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
the button (repeatedly, if necessary)
until the display will read:
From here, proceed as follows:
(if this is the current option)
For wireless siren, refer to "low", "mid" and "hi"
options as "squawk enable".
You may now select any other item on the USERS
SETTINGS menu or quit the programming process by
clicking . When "<OK> TO EXIT" is
displayed, click .
Setting Time and Time Format
Having entered your Master User Code successfully
(see Entering the User Settings Menu, above), click
until the display reads:
A. If 12h format is desired, continue as follows:
(if this is the current option)
(time
digits] (e.g.
12:55A)
Note: To enter “A” - press [] or to enter “P” - press [#].
B. If 24h format is desired, continue as follows:
[time
digits] (e.g.
19:55)
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.