Visonic PowerMax Complete - SMS Reporting and System Testing; SMS Reporting Details; Conducting a Walk Test

SPECIAL FUNCTIONS
D-302755 PowerMaxComplete User's Guide 21
Command
Individual Partition SMS Format
All Partitions SMS format /
Partition Disable
1
Arm AWAY
“AWAY <code>”
or
“AW <code>”
“P# AWAY <code>”
or
“P# AW <code>”
2
Arm AWAY instant
“AWAY INST <code>”
or
“AWI <code>”
“P# AWAY INST <code>”
or
“P# AWI <code>”
3
Arm AWAY Latchkey
“LATCHKEY <code>”
or
“LK <code>”
“P# LATCHKEY <code>”
or
“P# LK <code>”
4
Arm AWAY Latchkey instant
“LATCHKEY INST <code>”
or
“LKI <code>”
“P# LATCHKEY INST <code>”
or
“P# LKI <code>”
5
Arm HOME
“HOME <code>”
or
“HM <code>”
“P# HOME <code>”
or
“P# HM <code>”
6
Arm HOME instant
“HOME INST <code>”
or
“HMI <code>”
“P# HOME INST <code>”
or
“P# HMI <code>”
7
Disarm
“DISARM <code>”
or
“DA <code>”
“P# DISARM <code>”
or
“P# DA <code>”
8
Turn PGM on
“PGM ON <code>”
“P# PGM ON <code>”
9
Turn PGM off
“PGM OFF <code>”
“P# PGM OFF <code>”
10
Define custom house identity
(see note)
“HOUSE NAME <code> <house ID>”
or
“HN <code> <house ID>”
“P# HOUSE NAME <code> <house ID>”
or
“P# HN <code> <house ID>”
11
Query system status
“STATUS <code>”
or
“ST <code>”
“P# STATUS <code>”
Or
“P# ST <code>”
Note: House ID includes up to 16 characters, for example JOHN'S HOUSE.
Reporting by SMS
This option is applicable only if the GSM Module is
installed. The PowerMaxComplete system can send
SMS messages to a registered SMS telephones (up
to 4). (The SMS telephone registration is preselected
by the system installer).
The reported SMS messages are quite clear and self-
explanatory and therefore are not detailed in this guide.
Example of the reported SMS messages:
 JOHN’S HOME
**AWAY**
 JOHN’S HOME
**DISARM**
 JOHN’S HOUSE
POWERMAX: LOW BATTERY
GARAGE: LOW BATTERY
 JOHN’S HOUSE
STATUS MESSAGE 01
(Event list is displayed)
Note
Status messages can be sent only to a calling
telephone whose identity number is not blocked by
the user!
Note: The PowerMaxComplete may react with a
delay to received SMS messages if a GPRS session
is in progress at the same time.
Conducting a Walk Test
The walk-test is an indispensable operation by which
you verify that all detectors function properly, without
disturbing the neighbors with loud sirens. The test
must be performed at least once a week, and
should include all detectors in all zones.
Before performing walk-test, all the detectors must
be in normal state. Normal state is achieved when no
motion is made for at least 2 minutes.