VisorJet VJS-B620-2-LPR - Page 87

87
ВАРШ.201219.009РЭ
Tab
Button
Description
Automatic
return
Enable
Allows the PTZ camera to automatically return to the preset
home position after a period of delay. Check the box to enable
Delay
Set the delay time for starting the auto-return mode, 5-720s.
Auto-return
mode
The preset point will take effect at startup
Auto-return ID
Select a preset point in the list, press the "call" button to check
the location. You can also select your current location.
PTZ limit
Limit mode
The PTZ camera can be programmed to move within a config-
urable range (left / right).
Manual limit: on the control panel, pressing the right / left
buttons will prevent the camera from turning beyond the spec-
ified limits.
Scan Limit: In scan mode, will prevent the camera from turn-
ing beyond the specified limits.
Enable
When pressing, set the extreme positions of the left and right
limits, press, OK and save.
Mode status
Shows the status: limited or not.
Starting
position
Install
Set the starting position of the camera, to which it will return
after performing manual or automatic adjustments.
Clear
Delete memorized position
Activation
Set the starting position
Privacy mask
Add to
Allows you to cover some areas in the image with a mask and
prevent surveillance and recording in these areas. The mask
area does not move when you move the camera. A maximum
of eight mask areas can be specified.
Clear
Remove mask from current image
Delete
everything
Remove all masks, including those not included in the image.
Scheduled
tasks
Enable
Scheduled Tasks
Setting up the automatic execution of a specific action in a
user-defined period of time
Close / Auto /
Preset / Patrol /
Pattern / Check.
Select a task from the pop-up menu or check the box in the
graphic display of the task to the right of the schedule: Close /
Auto / Preset / Patrol / Pattern / Check.
The scheduled tasks function takes precedence over the Auto-
return function. When these two functions are set at the same
time, only the scheduled tasks function takes effect.
Schedule
settings
Set a schedule and task details.
The time of each task cannot be overlapped. Up to 10 tasks
can be configured for each day.
Recovery time
Set the recovery time for the task (from 5 to 720 seconds).
You can also set the idle time before the PTZ camera starts
the task.
Autotracking
Enable
Allows you to rotate the camera automatically to track moving
objects.