Section 3 - Programming
Operation Manual
VKI Publication #100308-003
Wiper Home Position
This option reinitializes the brewer wiper to its home position (same procedure that occurs
when the waste bin is removed and re-inserted).
Remove Filter
This option causes the brewer piston to cycle all the way to the bottom of the cylinder, which
will "pop" (unclip) the filter screen from the piston. The piston then moves to the top of the
cylinder so that the filter screen can be easily retrieved.
Calibrate Powder Level
This option automatically calibrates the powder motors and dispensers. Note that the machine
comes pre-calibrated from the factory, therefore running this cycle is not necessary. Should you
replace one of the powder motors or one of the powder dispensers, we recommend that you
execute this calibration cycle.
This cycle must be executed with empty powder dispenser(s). Do not run this
cycle if there is product in the powder dispenser(s) as the calibration will not
be accurate and the whipper bowls will fill with powder.
After the cycle is finished, it takes several vends for the dispenser(s) to properly complete their
calibration. The machine can be used normally throughout this brief period.
To Next Page
Loading...
