Section 4 - Maintenance
Operation Manual
VKI Publication #100308-003
► Inspect Electrical Wiring and Components - inspect all of the equipment wiring,
terminals, connectors and electrical components (valves, motors, relays, element,
etc.) for signs of wear, damage or overheating at connection points. Replace them,
if required.
► Inspect Water Hoses and Tubing - inspect all plumbing connections, water hoses,
tubing, clamps, fittings and water related components (valves, water tank, etc.) for
signs of wear or damage. Replace them, if required.
Every 3 Years
► Replace the following: heater element, thermal cut-off switch, external relays, all
seals and gaskets and o-rings.
► Refurbish the Brewer - the brewer must be disassembled and all worn components
must be replaced.
Miscellaneous
► Run the Brewer Rinse Cycle when prompted by the machine (a message appears
on the touch screen).
► Run the Powder Rinse Cycle when prompted by the machine (a message appears
on the touch screen).
► Verify Water Tank Components - dependant on the local water conditions, inspect,
clean or replace components, as required.
► Cleaning the Coffee Dispenser - empty, remove, and clean the coffee dispenser
with warm water and dish soap. Thoroughly dry the dispenser before re-installing
it. For detailed information about removing the coffee dispenser, consult the
Eccellenza Touch Service Manual (VKI Publication #100309-001).
► Cleaning the Powder Dispensers - empty, remove, and clean the powder
dispensers with warm water and dish soap. Thoroughly dry the dispensers before
re-installing them. For detailed information about removing the powder dispensers,
consult the Eccellenza Touch Service Manual (VKI Publication #100309-001).
To Next Page
Loading...
