Voltech PM1000+ - Page 28

THE MENU SYSTEM
Page 28 © Voltech 2010 PM1000+ Power Analyzer User Manual
on which mode you are in. The same applies for remote communications since
the "FRD?" command, which is used to return results, only returns the results
displayed on the screen, in the order in which they are displayed.
The table below lists which measurements are available in which mode, along
with which measurements are displayed by default for the selected mode:
Mode
Measurement
Normal
Ballast
Inrush
Standby
Power
Integrator
Vrms
*
*

*
*
Arms
*
*
*
*
Watts
*
*
*

VA




Var




Freq
*
*

*
*
PF
*
*
*
*
Vpk+


*
Vpk-


*
Apk+


*
Apk-


*
Vdc


Adc


Vcf



Acf


Vthd



Athd


Z

R

X

Hr

Whr
*
VAHrs

VArHr

Ahr

V-harm



A-harm


V range





A range





 = Measurement available
* = Displayed as default
Also, depending on which mode you change to, other settings may be changed.
The changes are listed below: