Voltech PM1000+ - 5 Remote Operation; Overview; Command Listing

REMOTE OPERATION
PM1000+ Power Analyzer User Manual © Voltech 2010 Page 38
5. REMOTE OPERATION
5.1. OVERVIEW
Using the remote commands the PM1000+ can be used to perform high speed,
complex or repetitive measurements.
5.2. COMMAND LISTING
Commands may be in upper or lower case.
Please see the next section for examples.
“*CLS”
Clears Standard Event Status Enable
Register (ESE) and Data Status Register
(DSR).
“*ESE <value>”
Sets the Standard Event Status Enable
Register (ESE). The <value> sent is a
decimal value.
“*ESE?”
Returns the value stored in the Standard
Event Status Enable Register (ESE) as
decimal value.
“*ESR?”
Returns the Standard Event Status
Register (ESR) as decimal value.
"*IDN?”
Returns the product ID string.
“*RST”
Resets the unit to default settings. This
command leaves communication settings
unchanged.
“*STB?”
Returns the Status Byte Register (STB) as
a decimal value.
“:AVG <value>”
Enable or disable averaging of results
(averaging depth of 4).
<value> = 0 → Disable (default)
<value> = 1 → Enable