THE MENU SYSTEM
Page 34 © Voltech 2010 PM1000+ Power Analyzer User Manual
GPIB Address
Enter the GPIB address and press OK.
Default address is 6. The address is unchanged after a “*RST” or “:DVC”
command.
Printer Select
An Enhanced Comms version of the PM1000+ can select between a traditional
25-pin printer port, a USB printer port or a RS232 printer port. Select the
desired printer interface and press to confirm.
The USB printer port is not available on the Basic Comms version of the
PM1000+.
The baud rate for the RS232 printer port is set in the RS232 Baud Rate menu as
described above.
RS232 printing is implemented with no flow control.
The selected print port is unchanged after a “*RST” or “:DVC” command.
Ethernet Configure
The Enhanced Comms version of the PM1000+ offers Ethernet communications
through a standard Ethernet port using TCP/IP.
The Ethernet port will make a TCP/IP connection on port 5025. Port 5025 is
designated by the Internet Assigned Numbers Authority (IANA) to be a SCPI port.
Use the IP Selection Method menu, and the keys, to opt for a dynamically
assigned IP address, by selecting “Set IP using DHCP”, or a fixed/static IP
address by selecting “Fix IP Address” with the button.
To view the current IP settings, choose “Current IP Settings” in the Ethernet
Setup menu. This allows the user to view the current IP address, subnet mask,
and default gateway.
To configure the static IP address, choose “Static IP Settings” in the Ethernet
Setup menu. This allows entry of the IP address, the subnet mask and the
default gateway. After entering the relevant data press the OK button, in each
menu, to apply.
To Next Page
Loading...
