SOFTWARE
PM1000+ Power Analyzer User Manual © Voltech 2010 Page 55
6. SOFTWARE
There are a number of useful software utilities available for the PM1000+. The aim of
these utilities is to enable users to gather information easily from the PM1000+ and
record this information on a PC.
6.1. IEC 61000-3-2/3 PRE-COMPLIANCE SOFTWARE
Aim
The aim of the IEC 61000-3 software for the PM1000+ is to provide pre-compliance
measurement information for the IEC 61000-3-2 current harmonics standard and the
IEC61000-3-3 voltage flicker standard.
The software is provided at no cost and can be installed on as many PCs as you wish.
However, the software will only work with a PM1000+ that has had the IEC option
enabled (see section 4.9). To help you decide whether the feature is what you require,
each PM1000+ will allow 10 current harmonic or flicker tests to be run before purchase
is required. Please contact your Voltech agent to purchase the feature.
Where to find it
The software can be found on Voltech‟s web site at www.voltech.com in the software
and firmware section.
Software Installation
Double click on the file “PM1000IEC6000.exe” and follow the on screen instructions.
During the installation you will be prompted to install the National Instruments NI-VISA
runtime. Please install this. If a later version exists on your PC, then these files will not
be over-written.
Also, you will be prompted to install a Microsoft Access 2000 run time engine. Please
install if necessary.
To Next Page
Loading...
