SOFTWARE
Page 58 © Voltech 2010 PM1000+ Power Analyzer User Manual
Detected PM1000+ on USB
Configure the Fluctuating Harmonics Test
Next from the top-level menu, open Product → Configure for Harmonics. You will now
see the configuration window for the Fluctuating Harmonics Test. This can be seen
below:
Configure for Test
Source
Enter your source voltage and frequency in this box. Note that the IEC 61000-3
standard has not set limits for systems with nominal voltages less than 220 V (line-to-
neutral). The software will give a warning for settings that will cause non-compliance
with the IEC 61000-3-2 standard.
To Next Page
Loading...
