4 Fill the tank with the quantity shown in the display,
POS 2.
Wait 10 seconds.
Press to confirm that the tank has been filled
to the indicated level.
5 Repeat the procedure for POS 3 , POS 4 and POS
5. Confirm by pressing the wheel at each position.
.
Full Fuel Tank Calibration
For this
method the tank must be full and calibration of
the fuel level sensor takes place in one step. This
means that the fuel level value will be approximate,
and therefore all trip data based on remaining fuel must
be seen as approximate values.
1
Turn to Fuel Tank and press
to reach the
submenu.
2
Select
Full Fuel Tank Calibration and press
.
3 Fill the
fuel tank. Confirm that the fuel tank is full by
pressing
.
IMPORTANT!
Settings for Fuel Tank Volume, Empty Tank Calibra-
tion and Fuel Alarm Level should only be carried out
by an authorized Volvo Penta workshop.
Speed Factor
The speed factor must be set while the boat is under
way. Compare the displayed boat speed value with
GPS
data (or another boat) and adjust the speed factor
until the values agree.
The setting just needs to be done on one display for it
to be shown at all stations and on all displays
1 Go from the settings menu to Speed Factor and
press to reach adjustment.
2
Use to set the value
Press to confirm the setting.
Multipoint
Full Fuel Tank Calibration
Speed Factor
Calibration and Settings
47705796 05-2014 © AB VOLVO PENTA 125
To Next Page
Loading...
