Volvo Penta IPS - Oil Filter;By-Pass Filter, Change

Oil Filter/By-pass Filter, Change
The oil
filter and bypass filter must be replaced at every
oil change.
Remember to hand the old filters in to a re-cycling sta-
tion.
WARNING!
Hot oil and hot surfaces can cause burns.
1 Place a collection vessel underneath the filter drip
tray to avoid oil spillage.
2
Clean the filter bracket.
3 Unscrew the bypass filter (1) and the oil filters (2)
with a suitable puller.
4 Check that the mating surfaces on the filter bracket
are clean and that no remains from the old gaskets
are left.
5 Moisten the gaskets on the new filters with engine
oil.
6 Screw on the filter by hand until the rubber gasket
touches the filter bracket mating surface. Then turn
a further 3/4 to 1 turn.
7 Start the engine, run at low idle, and check that no
leakage occurs. Check the oil level after the engine
has stopped.
2
1
2
P0010347
Maintenance
47705796 05-2014 © AB VOLVO PENTA 89