Volvo Penta IPS - Page 23

Units
Setting the
units (metric, US or Imperial) and distance
units (km, NM or miles) that distances will be shown in.
Language
Setting the language that information will be shown in.
Speed Factor
When setting the speed factor, refer to Speed
Factor page 125.
EVC Information
Information about components, software and functions
installed. Installed functions are checkmarked.
Service
The drive is fitted with a sensor that monitors oil level
and quality. If the oil level in the drive is low or if there
is water in the oil, the helmsman is alerted by an audi-
ble alarm and a message is shown on the display
simultaneously. Every time oil is changed, the water-
in-oil sensor must be calibrated; refer to
Service page 121
Warning Manager
If the system discovers a fault, the helmsman is alerted
by a message on the display. The fault message must
be acknowledged by pressing OK.
All fault messages are stored in Warning Manager, the
drivetrain affected is also shown, the fault described
and suitable actions suggested. For further information
on the fault messages concerned, refer to Fault Code
Register page 71.
Warning Manager
Instruments and Controls
47705796 05-2014 © AB VOLVO PENTA 21