Vox Lil Looper User Manual

21
Creating phrases
) p. 19 “Creating phrases of a precise length (Loop
Quantize)”
5. Tostoptheloop2,presstheLOOP2pedaltwice.
The Loop 2 PLAY status LED will blink green
slowly.
The recording/playback function of the Lil’
Looper
The recording/playback function of the Lil’ Looper
has two modes.
Sync mode (set at the factory)
In this mode, the correlation of the two loops will be
maintained when recording.
For example, Loop 1 will playback while Loop 2 is
recorded. When playback is performed, the head of
Loop 2 will always be at the same position as Loop 1.
Also, the sound will not be output if playback is
stopped, but loop playback will always continue
internally. The stopped position of a phrase is dierent
from the start position of the next playback.
When stopped, the PLAY status LED will blink red at
the loop head.
Note: If one loop is recording and the other loop is
stopped, the length of the loop that is recording will be
automatically corrected so that it becomes an integral
multiple of the length (integral multiple) of the loop
that is stopped.
This mode is set at the factory. As a general rule, this
mode should be used.
Individual mode
In this mode, the correlation of the recording and the
playback position of the two loops is not maintained,
and the two loops are operated separately. Each loop will
not maintain the correlation of the playback position,
and playback will always be started from the head.
Switching modes
When a loop does not contain a phrase, the two modes
can be switched when the EFFECT buon and the CLEAR
buon are held down simultaneously for 2 seconds.
Therefore, a mode can be switched each time the buon
is pressed.
When a mode is switched, the TAP buon and CLEAR
buon will blink and light up to indicate the current
mode.

Vox Lil Looper Specifications

General

Brand	Vox
Model	Lil Looper
Category	Music Pedal
Language	English