Vox Lil Looper - Power Management; Turning Power On; Turning Power Off; Creating Phrases

15
Creating phrases
Turning the power on
1. Makesurethatthevolumeofyourampor
mixerissucientlylowered,andthenturnthe
Lil'Looper’sPOWERswitchtotheONposition.
The AUTO REC, METRONOME, TAP and CLEAR
buons light up green when the power is turned on.
2. Turnonthepoweroftheconnectedampor
mixer,andraisethevolume.
3. Playyourguitar,andadjustitsvolumewithout
allowingthePEAKLEDtolight-up.
Note: The Lil' Looper contains an auto power-o
function. The power will automatically turn o
approximately four hours aer the last user input
occurred ()p. 30 “Auto Power-O function”).
Turning the power off
1.
Lowerthevolumeofyourampormixer.
2. SetthePOWERswitchtotheSTANDBYposition.
Creating phrases
Let’s record phrases to Loop 1 and Loop 2.
The phrase recorded on a loop will be deleted if
the power is turned o.
Recording on Loop 1
1.
Connect your guitar or mic and amp to the
Lil'Looper,andturnonthepower.
)p. 14 “Connect your instrument and turn on the
power”
Checkingthestatusofeachloop
The PLAY status LEDs and REC status LEDs for
Loop 1 and Loop 2 indicate whether each loop
contains a phrase.
Note: If you haven’t recorded anything into the
loops, there’s no need to check.
If the PLAY status LED is unlit, that loop does not
contain a phrase.
If the PLAY status LED is blinking green slowly,
a phrase has been recorded in that loop, and the
phrase is stopped.