Vox Lil Looper - Foot Switch Control; Controlling Loops and Effects; Effect Control (Factory Settings); Loop Control with Foot Switch

29
Controlling the Lil’ Looper with a foot switch
If an eect or parameter value that has been saved
in advance is changed, the EFFECT buon will
blink.
3. HolddowntheEFFECTbuon.
The eect has been saved if the EFFECT buon
blinks, then lights up.
Controlling the Lil’ Looper with a
foot switch
When the optional VOX VFS2 foot switch is connected
to the EXT.SW jack, it can be used to control the loops
and eects.
Be sure to connect the VOX VFS2 foot switch
while the power is turned o. Connecting or
disconnecting the foot switch while the power is
on can cause a malfunction or damage to the unit.
Do not press the switches of the VOX VFS2 foot
switch simultaneously. Doing so can cause a
malfunction.
1. HolddowntheEFFECTbuonandtheAUTO
RECbuonfor2seconds.
Each time the buon is pressed, the seing will be
switched. If the seing is switched, the AUTO REC
buon and METRONOME buon will blink or
light up to indicate what can be controlled.
Blinks red → Lights up → Does not light up:
Controls the eects with the foot switch.
Blinks green → Lights up → Does not light up:
Controls the loops with the foot switch.
Controlling an effect (set at the factory)
You can switch an eect on or o with switch 1 and
select the eect type with switch 2.
The function for controlling an eect with the foot
switch is set at the factory.
Controlling a loop
You can stop the playback and delete the data of each
loop. Switch 1 corresponds to Loop 1 and switch 2 to
Loop 2.