31
Appendix
Call log empty
There are no call log entries.
Copy from DIR..
The telephone is loading entries from Directory for speed
dial assignment.
Call log empty
There are no call log entries.
Directory empty
There are no directory entries.
Directory full
The directory is full.
Ended X:XX:XX
You have just ended a call.
Incoming call
There is an incoming call.
Line in use
A system handset or another telpehone on the same line
is in use.
Low battery
The battery needs to be recharged.
New voicemail
There are new voicemail message(s) from the telephone
service provider.
No battery
No battery is installed. Follow the directions for battery
installation on page 4 to install the battery before charging.
No line
There is no telephone line connected.
No signal
Communication between handset and telephone base is
lost during a call.
Not available
One handset is already viewing the call log or directory
and another handset attempts to review it.
Number repeated
The telephone number entered is already stored in the
directory.
Out of range OR
no pwr at base
The handset cannot communicate with the telephone
base. Check the telephone base power connection or
move closer.
Phone X:XX:XX
The handset is on a call.
Place in charger
The battery is very low. Place the handset in the telephone
base or charger for recharging.
Ringer muted
The handset ringer is muted temporarily during an
incoming call.
Ringer off
The handset ringer is turned off.
Saved
Your selection has been saved.
XX missed calls
There are calls that have not been reviewed in the call log.
XX new messages
There are new messages in the answering system.
** Paging **
All system handsets are being paged.
Screen display messages
Appendix