VTech DS5151-2 User Manual

9
If you place the handset in the telephone
base or the charger without plugging in the
battery, the screen displays No battery.
Battery
indicators
Battery
status
Action
The screen
is blank,
or displays
Place in
charger and
flashes.
The battery
has no or
very little
charge. The
handset
cannot be
used.
Charge
without
interruption
(about 30
minutes).
The screen
displays
Low battery
and flashes.
The battery
has enough
charge to
be used
for a short
time.
Charge
without
interruption
(about 30
minutes).
The screen
displays
HANDSET X.
The battery
is charged.
To keep
the battery
charged,
place it in
the handset
charger when
not in use.
When the battery is fully charged, you can
expect the following performance:
Operation
Operating
time
While in handset use
(talking*)
Up to 7 hours
While in speakerphone
mode (talking*)
Up to 3.5 hours
While not in use
(standby**)
Up to 5 days
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging nor in use.
•
Battery backup
When there is a power failure, all
handsets display Put HS on base to
power base and Out of range OR No
pwr at base alternately. Put a charged
handset in the telephone base to back
up the telephone base power for some
basic phone operations for a short period
of time. During this period, you cannot
use the answering system.
When a handset is put in the telephone
base, it displays Powering base... Don’t
pick up. At this time, use other handsets
for some basic phone operations. You
may use the handset which is put in the
telephone base for making or answering
calls via the handset speakerphone, but
do not pick up the handset while using it.
NOTE
When the cordless handset you put in
the base does not have enough charge
to back up the telephone base power,
the handset displays Not enough batt to
power base.
•

VTech DS5151-2 Specifications

General

Brand	VTech
Model	DS5151-2
Category	Cordless Telephone
Language	English