36
37
Temporary tone dialing
If you have pulse (rotary) service only,
you can switch from pulse to touch-tone
dialing temporarily during a call. This is
useful if you need to send touch-tone
signals to access your telephone banking
or long distance services.
During a call:
1. Press TONE on the handset.
2. Use the dialing keys to enter the
relevant number. The telephone
sends touch-tone signals.
3. The telephone automatically returns
to pulse dialing after you end the call.
View dialing options
The incoming caller ID log entries have
10 digits (the area code plus the seven-
digit number). You can add 1 in front
of the telephone number before you
dial in the caller ID log or store it to the
phonebook.
While reviewing the caller ID log, press
(pound key) or 1 repeatedly if you
need to add or remove 1 in front of the
telephone number before dialing or
saving it in the phonebook.
When the number is in the correct format
for dialing, call the number by pressing
HOME/FLASH or on cordless
handset.
Join a call in progress
Another handset or the telephone
base can join you on home call. The call
continues until all parties hang up. You
can share an outside call with up to two
system devices.
• When a handset or telephone
base is already on a call, press
HOME/FLASH or on another
handset to join the call.
-OR-
When a handset is already on a call,
press HOME on the telephone base
to join the call.
• Press OFF/CANCEL or place the
handset in the telephone base or
handset charger to exit the call. The
call continues on the other handset
until both handsets hang up.
-OR-
Press HOME on the telephone base
to exit the call. The call continues on
the other handset until both devices
hang up.
NOTE
• If you have paired a DECT 6.0 cordless
headset to the telephone base, you
can also join a call in progress using
the paired device. Refer to the user’s
manuals of the respective product
for more information.
Find handset
This feature helps you find all system
handsets.
CAUTIONS
• Do not press and hold FIND HS for
more than four seconds. It may lead
to handset deregistration.
• If the handset displays To register HS...
and ...see manual, refer to Frequent
asked questions to register the handset
back to the telephone base.
To start paging
• Press FIND HS on the telephone base
when it is not in use. All idle handsets
ring and display **Paging**.
To end paging
Press HOME/FLASH,
CELL,
OFF/CANCEL or on the handset.
-OR-
• Press FIND HS again on the telephone
base.
-OR-
• Place the handset in the handset
charger.
NOTE
• If you press MUTE/DELETE/VOICE on
a handset, the ringer of that handset
is silenced but the paging tone
continues on the other handsets.
To Next Page
Loading...
