VWR Puranity TU+ | 27
Installation |
Chapter 7
4 a. Locate the RO/pretreatment
cartridge.
b. Place the RO/pretreatment
cartridge in the front part of
the system and insert the
three quick connectors into
the RO/pretreatment
cartridge. When you hear an
audible click you can be
sure that the quick
connectors have been
inserted correctly.
NOTE!
The quick connectors are attached to
the system in such a manner so it is
to prevent installing the
RO/pretreatment cartridge
incorrectly.
5 a. Use the R3/4“ feedwater
connecting kit, supplied with
the system, to connect the
Puranity TU+ system with
the feedwater tap. Therefore
push the R3/4“ union nut
over the outer diameter 1/4“
tube und push in the tube
into the fitting and then
connect the open end of the
outer diameter 1/4“ tube to
the feedwater connection of
the Puranity TU+ panel.
b. After this screw in the R3/4“
union nut with the dirt
screen onto the feedwater
tap.
Step Action Figure
To Next Page
Loading...