IVTM
6
Installation
37
Locations wher
able as the attachme
e diagnostic ports are already located would be specially suit-
nt location.
II
itable is the AK 192 of Apparatebau Kirchheim-Teck GmbH & Co.
– lug.
– Install the cable joint box if required, such as, for example, the WABCO VCS
cable joint box 446 010 092 2.
Also su
Pull off the ABS p
Co s with regard to the short circuiting of batteries inside the vehicle. nsider any risk
– ng to the wiring diagram using cable ties in parallel with al-
6.6 Start-up
Install cables accordi
ready existing wiring harnesses.
Form large loops from long lengths.
– Connect IVTM cabling to existing cabling.
– Connect the ECU.
Co
PIN (PIN 2) after the training course.
mmissioning requires a system training course. You may ask WABCO for the
No WABCO diagnosis is possible on vehicles having integrated display. In this
case the IVTM is basically parameterised through manufacturer-specific diagnosis.
Proceed as follows to put the diagnostic software of the IVTM into operation:
Commissioning schedule:
– Make sure that the IVTM system is installed according to the instructions in
chapter, see chapter 6 "Installation", page 31.
– Check for co
rrectly set tire pressures on the wheel module.
– Connect the computer to the vehicle using the diagnostic cable and interface.
– Start the diagnostic software and enter Pin2.
– Switch on ignition. Ensure power supply of trailer if necessary.
– Start "Startup" menu in diagnostic program.
– Enter vehicle type and vehicle data.
– Enter IDs of wheel modules and values of tire pressure (according to vehicle
manufacturer) in list of axes and wheels.
– Stimulate the wheel modules. For this purpose, touc ng of each
el for 5 seconds using a magnet (2 kg re-
tention force) or using a bar magnet parallel to the IVTM logo.
following hours their
pressures any 30 s.
h the housi
whe module below the sticker "IVTM"
The wheel modules afterwards will transmit for the
To Next Page
Loading...
