9
TEBS E
Start-up
166
Requirements for parameter setting
TEBS E system training is necessary to create a parameter set. Only after receiv-
ing the PIN are you authorised to make changes using the TEBS E Diagnostic
Software see chapter 11.2 ‘System training and PIN’, page 184.
There is a new PIN for TEBS E2 or higher, therefore another training
course is required. Speak to your WABCO partner.
Ordering TEBS E Diagnostic Software
Open the WABCO website http://www.wabco-auto.com
.
Here click the link myWABCO.
Help on logging in can be obtained by pressing the Step-by-step instructions but-
ton.
After successfully logging in, you can order the TEBS E Diagnostic Software via
myWABCO.
Please contact your WABCO partner if you have any questions.
– Have the data from the brake calculation and the GIO diagram number ready
for the parameter setting.
– Open the TEBS E Diagnostic Software.
The start window is opened.
What's new in the TEBS E Diagnostic Software?
Click on the Help => Content => What's new?
Click on the software version for which you want to read about innovations.
9.2 Functional test
Setting the parameters is usually followed by the functional test:
– You can only perform the function test (EOL test) if you have taken part in the
TEBS E training.
You can use the TEBS E Diagnostic Software to carry out various simulations via
the Control menu.
To Next Page
Loading...
