11
TEBS E
Workshop notes
184
11 Workshop notes
11.1 Maintenance
The TEBS E system is maintenance-free.
– Drive to the next workshop immediately if warning messages occur.
11.2 System training and PIN
After participating in a training session or E-Learning, you can request a PIN for the
TEBS E Diagnostic Software from us. With this Personal Identification Number you
can enable enhanced functions in the software and can use these to change the
settings in the electronic control units.
The training session or the post-training must take place in 2010 or
later.
Action required PIN
type
Training
Calibrating height sensors PIN 2 TEBS E training or E-
Learning
Changing the modulator using a protected parame-
ter set
PIN 2 TEBS E training or E-
Learning
Setting all function parameters PIN TEBS E training
WABCO University
You will find more detailed information on our courses and E-Learning on the
WABCO website.
Open the WABCO website http://www.wabco-auto.com
.
Click the link myWABCO.
Help on logging in can be obtained by pressing the Step-by-step instructions but-
ton.
Once you have successfully registered and logged in you can book training courses
and work through E-Learnings via myWABCO.
Please contact your WABCO partner if you have any questions.
To Next Page
Loading...
