37
Assembly of the Internal Sensor SMS
2.
During assembly, the tire bead must not be pressed against the wheel electronics. Otherwise
there is a risk that the internal sensor will be destroyed by the contact due to tensile or
compressive forces.
Make sure that a tire bead is not pressed onto or pulled over the sensor.
3.
4. Pull the second tire bead onto the rim.
During assembly, the assembly head must have a minimum distance of 20 cm to the internal sensor.
5. Remove the complete wheel from the assembly machine.
6.
stuck on the housing.
13.5 Assembly of the Wheel
manufacturer.
Installation of the internal sensor SMS is completed.
To Next Page
Loading...
