33
Assembly of the Internal Sensor SMS
13 Assembly of the Internal Sensor SMS
13.1 Safety Information
Always observe the applicable hazard warnings and correct procedures on the assembly machine. This
information has priority over these instructions.
Replace the internal sensor if the pressure opening is blocked with foreign bodies.
Use fastening straps that are approved for the corresponding rim size (see Section 13.3 Installation of the
Internal Sensor, page 34, https://www.wabco-customercentre.com/catalog/docs/8150102293.pdf).
Remember to write down the sensor IDs with the corresponding wheel positions when
installing the sensors. Use the install form below.
Do not apply compressed air, assembly paste, detergents, or other cleaners to the internal sensor.
Never clean the rim with high pressure when the tires are removed, and the internal sensor still installed.
Remove contaminations only with a clean, lint-free cloth.
If the housing is visibly damaged, it must be replaced.
Replace the internal sensor if you identify:
Foreign bodies can be seen in the pressure opening, or
The battery of the internal sensor has reached the end of its life.
To Next Page
Loading...
