Wacker Neuson 0620320 User Manual

Drive System RD 12/RD 12A
wc_tx000667gb.fm 50
5.2 Adjusting the Drive Control Cable
Background If the roller tends to drift in either direction when the forward/reverse control is in
NEUTRAL, the drive control cable (a) must be adjusted.
Prerequisites  Machine on a hard, level surface
 Engine running
 Forward/reverse control in the NEUTRAL position
Procedure Follow the procedure below to adjust the drive control cable.
1. Loosen the lock nut (b).
2. Move the turnbuckle (c) as needed until machine movement stops.
If adjusting the turnbuckle does not achieve the desired results, a gross adjustment
can be made at the nut (d) and then fine-tuned as described above.
The drive control cable has now been adjusted.
wc_gr004121
a
b
d
c

Wacker Neuson 0620320 Specifications

General

Brand	Wacker Neuson
Model	0620320
Category	Utility Vehicle
Language	English