BA ET18, 20, 24 en* 1.5 * et18_20_24b510.fm 5-27
Operation 5
Hammer operation
Important information regarding hammer operation
Use the canopy version only with a shatter protection during hammer
operation.
If the machine is equipped with a cabin (option), the front window must be
closed.
– see chapter “ Shatter protection (option)” on page 4-24
Danger of piercing/penetration by objects from the front!
Work involving risk of piercing/penetrating by objects from the front can
cause accidents with serious injury or death.
► During operation, all persons must stay clear of the job site of the
machine.
► Do not position the vehicle under the workplace during demolition,
since debris could fall onto the machine.
► Observe the mandatory limits of the work area.
► Do not hammer horizontally or upward.
► Only hammer with attached shatter protection or closed front
windshield.
Accident hazard due to tipping over of machine!
A tipping machine can cause serious injury or death.
► During operation, all persons must stay clear of the job site of the
machine.
► Do not perform any demolition work under the machine. This could
cause the machine to tip over.
► The machine can lose its balance and tip over if a hammer or other
heavy attachment is used.
► Never turn, lower or set down the attachment abruptly.
► Do not extend or retract the boom abruptly.
► Do not use the impact force of the attachment to perform demolition
work. Broken or falling pieces can cause serious injury.
► Use a hammer only at machine standstill.
In combination with Powertilt, only use the smallest possible released
hydraulic breaker.
To Next Page
Loading...
