4-24 BA ET18, 20, 24 en* 1.5 * et18_20_24i400.fm
4 Putting into operation
Shatter protection (option)
Danger of piercing/penetration by fragments from the front!
Causes serious injury or death.
► A shatter protection must be installed on a canopy version if an
attachment (for example a hammer) causes fragments to fly around.
This shatter protection takes over the function of a front window. If the
machine is equipped with a cabin, the front window must be closed
during hammer operation.
► Note restricted work area (see Fig. 96/97)
► Machine operation is prohibited without a shatter protection.
Accident hazard in conditions of restricted visibility due to rain,
snowfall, dust, etc.
Can cause injury.
► Stop machine operation immediately.
Only a Wacker Neuson service center may install the shatter protection for
the first time.
Do not use brushes, steel wool or other abrasive cleaners for cleaning the
polycarbonate disk. Do not wipe dust in a dry state.
The shatter protection (canopy option) protects the user against fragments
from the front.
► The machine owner must ensure that the hazard situation is evaluated
and that the national regulations are observed.
► The machine owner must ensure that only work is performed that does
not require any higher protection.
► Accidents cannot be fully avoided despite equipping a machine with
protective structures.
The shatter protection cannot be combined with a protective Front Guard
structure.
To Next Page
Loading...
