BA ET18, 20, 24 en* 1.5 * et18_20_24i400.fm 4-25
Putting into operation 4
Job site
Work range height A: 120 cm (47 in), E: 50 cm (20 in).
Figures 96 and 97 refer to work with a Wacker Neuson hydraulic hammer.
Working with another attachment can modify the height of the job site.
Installing/removing the shatter protection
1. A minimum 2 persons are required for installing/removing.
2. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
3. Install/remove shatter protection A from the front and fasten/remove it
at the fastening points B with the fastening material supplied.
4. Tighten screws C at fastening points B to 25 Nm (18 ft.lbs).
Fig. 96Job site with shatter protection
E
A
Fig. 97Work area with shatter protection (top
view)
Fig. 98Shatter protection (assembly)
B
B
A
Fig. 99Shatter protection (assembly)
C
To Next Page
Loading...
