Drive System RD 12/RD 12A
wc_tx000667gb.fm 50
5.2 Adjusting the Drive Control Cable
Background If the roller tends to drift in either direction when the forward/reverse control is in
NEUTRAL, the drive control cable (a) must be adjusted.
Prerequisites Machine on a hard, level surface
Engine running
Forward/reverse control in the NEUTRAL position
Procedure Follow the procedure below to adjust the drive control cable.
1. Loosen the lock nut (b).
2. Move the turnbuckle (c) as needed until machine movement stops.
If adjusting the turnbuckle does not achieve the desired results, a gross adjustment
can be made at the nut (d) and then fine-tuned as described above.
The drive control cable has now been adjusted.
wc_gr004121
a
b
d
c
To Next Page
Loading...
Need help?
General
