57
EPG-SPRINT / EPG-SPRINT X
SERVICE MANUAL
VERSION 09/2017 ORDER NUMBER DOC2309350
8 PARAMETERS FOR SERVICE PURPOSES
Various parameters can be used to check and if necessary calibrate the individual air
outlets and production of high voltage on the low-voltage side.
Note:
Recalibration is usually only needed if individual valves or the rear panel print boards are
replaced. If an air valve incurs water or oil damage, it cannot be repaired by recalibrating it.
It must rst be cleaned or replaced.
Recalibration undertaken inaccurately or with unsuitable measuring equipment may
quickly be outside the tolerance established by WAGNER. In such cases, it is better not to
undertake calibration.
Incorrect calibration!
ATEX/FM approval ceases to apply.
Only allow a technical expert from a tested WAGNER service
department to undertake calibration.
DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Maintenance, repair or replacement of the control unit or its
components may only be performed by trained personnel in a
suitable location outside the hazard area.
In order to avoid the destruction of electronic components
(especially when packed), an unearthed person may never
touch the print.
Before starting any repair, it must be ensured that there is no
power connection.
Irrespective of the extent of repair, all electric and pneumatic
supply lines must be separated from the control unit.
DANGER
To Next Page
Loading...
Need help?
General
