97
EPG-SPRINT / EPG-SPRINT X
SERVICE MANUAL
VERSION 09/2017 ORDER NUMBER DOC2309350
16 SOFTWARE HISTORY
Software version Introduced from Modi cation/Description
A100 July 2009 First serial version
A101 August 2009 Changes in the calibration menu (con guration parameter "C41"
and "C42")
A102 July 2010 Problems with the input of the buttons at the front control are
recti ed.
A111 June 2011 1. Increase/reduce powder quantity via the extended interface for
the remote control (see service manual in Chapter 12.4).
2. Behavior changed after exit standby.
The recipe number and the recipe values (incl. temporary ones)
are retained just like before the standby.
3. Behavior changed so that the high voltage can be switched on
or o via the kV set point.
4. Flushing button is deactivated in automatic mode.
5. Behavior changed at remote control input:
In older versions, the positive edge of the signal at the ON/OFF
input was crucial. Now, only the status is evaluated.
6. Lock adds:
Additionally, the setting "PRO" (program storage locked) exists
in the con guration parameter "C13".
7. Monitoring function “E12: No coil current/cascade interrupt" will
be deactivated at set point settings less than 20 kV or less than
15 μA.
A120 August 2012 Blocked ushing in automatic mode is activated again.
Behavior changed, new with linkage of gun release for exhaust air/
interlocking. See operating manual.
16.1 EPGSPRINT
To Next Page
Loading...
Need help?
General
