WAGNER EPG-SPRINT - Handling Powder Paints; Using in Accordance with Instructions; For Use in Potentially Explosive Areas

8
EPG-SPRINT / EPG-SPRINT X
SERVICE MANUAL
VERSION 09/2017 ORDER NUMBER DOC2309350
2 CORRECT USE
2.1 DEVICE TYPE
Universal control unit for controlling electrostatic manual and automatic spray guns
2.2 TYPE OF USE
The EPG-SPRINT/EPG-SPRINT X/EPG-SPRINT XE control unit is intended for controlling
electrostatic manual and automatic powder spray guns of type A-P (2 mJ) according to
DIN EN 50050-2 and DIN EN 50177.
Incorrect use!
Risk of injury and damage to the device.
Only connect original WAGNER spray guns to the EPG-SPRINT/
EPG-SPRINT X/EPG-SPRINT XE control unit.
The PEM-C3R and PEM-T3R manual spray guns may not be
connected to the EPG-SPRINT/EPG-SPRINT X/EPG-SPRINT XE
control unit.
WARNING
2.3 USE IN AN EXPLOSION HAZARD AREA
The EPG-SPRINT/EPG-SPRINT X/EPG-SPRINT XE control unit is intended for use with powder
spray guns of types A-P up to 2 mJ in accordance with the prototype test PTB 06 ATEX 03/
PTB 12 ATEX 5001.
The EPG-SPRINT/EPG-SPRINT X/EPG-SPRINT XE control unit may be used in the dust
explosion zone (Zone 22) under the following conditions:
– Control unit correctly  tted in rack.
– Rack correctly and securely sealed on rear with associated cover.
– All plug connections are securely locked.
– All connections not needed (mains output, remote control) are sealed with dust
protection caps.