WANHAO I3 Plus - Installation Guide; Default Printer Configuration

Installation
1.5.3 Default Conguration
The following settings show the default conguration values of the WANHAO 3D Printer.
We’ve set these to provide optimal quality for your 3D printed models, however, if you wish to
adjust these settings, we recommend this to be done by only highly experienced users, as print
quality and 3D printer durability may be affected.
• General
Baudrate: 115200
Stepper Inactive: 360s
Max Inactive: 0s
• Acceleration
Print X: 1000
Print Y: 1000
Print Z: 100
Move: X
Move: Y
Move: Z
Jerk: 20.0
Z-Jerk: 0.3
• Feedrate
Max X: 200
Max Y: 200
Max Z: 2
Home X: 40
Home Y: 40
Home Z: 2
• Extruder
Steps/mm: 96.0
Start FR: 20
Max FR: 50
Accel: 5000
Stab. Time: 1
Wait Units: 0mm
Wait Temp.: 150C
Control: Dead Time
DT/PID P: 7.00
PID I: 2.00
PID D: 40.00
Drive Min 40
Drive Max 230
PID Max: 255
• Store to EEPROM: Save conguration settings to the internal storage, to be re-loaded on
reboot
• Load f. EEPROM: Return conguration settings to the last reboot
AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator I3 Plus
25