WANHAO I3 Plus - Expert Cura Settings for Retraction

Using Cura
6.6.5 Expert Settings
Expert settings will give you more specic options for your retraction, skirt, active cooling, inll,
support, brim, raft, and special settings. To gain access to this section you go to Expert > Open
Expert Settings or on your keyboard press Control + E.
Retraction
Retraction pulls lament out of your nozzle when it is not extruding to prevent your print head
from dripping on your object. This section is where you will control how your Extruder retracts its
lament.
Minimum Travel (mm)
This sets the minimum travel distance of your print head in order to retract. If your print
head is not moving this far during travel moves, it will not retract.
Enable Combing
This option prevents your print head from travelling over holes in the X/Y plane when
printing.
This will slightly increase print time, but will prevent strings from getting caught on the
holes during travel moves. We recommend keeping this setting on.
Minimal Extrusion before Retracting (mm)
This will control the distance at which retraction occurs if the printing movement exceeds
the minimum extrusion amount. This will prevent a retraction move, if your Extruder has not
put out Xmm of lament since its last retraction.
Z Hop When Retracting (mm)
This will raise your print head Xmm while retracting. This setting helps prevent ooze, and
strings from being deposited on your print.
AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator I3 Plus
43