WANHAO I3 Plus - Removing Filament from Extruder

Setup
3.3 Removing Filament:
1. With the printer initialised, press the Navigation Dial to enter the menu system.
2. Navigate to, and select Tool > Preheat PLA or Preheat ABS depending on the
material.
3. Check the temperature of the Extruder and plate on the LCD. When the temperatures are
within a few degrees of the target, you are ready to remove the lament.
NOTE: Preheat PLA/Preheat ABS will still be shown, even after temperatures have been reached.
4. Depress the Extruder spring lever. Push down on the lament gently so that it starts to
extrude from the nozzle.
5. When lament is extruding, quickly, but gently pull the lament upward. If it is done correctly,
the end of the lament will pull out into a thin hair like strand.
NOTE: The aim is to sever the lament where is it soft (inside the nozzle). Swift upward action will
ensure that the lament does not cool down before exiting the nozzle inlet. If the lament gets
stuck, please see the troubleshooting section.
3.4 Storage:
Both PLA and ABS laments are sensitive to moisture. If stored in a humid environment, the quality
of the lament can deteriorate, with a tendency to bubble and spurt from the nozzle tip. This will
affect print quality, so when storing PLA or ABS for an extended period of time, follow these tips.
• Store in a sealed, air tight bag/container. We recommend a vacuum seal bag
• Store with a silica gel (moisture absorber) pack. One is included with each lament spool
4. Using the SD Card
4.1 Loading les from your Computer:
1. Insert your SD Card into a card reader or memory card slot and connect to your
computer (refer to your computer manual for further instructions if required).
2. The Micro SD Card will appear as a folder (refer to your computer manual for further
instructions if required).
3. Copy your converted GCODE les to the SD card, then safely remove.
AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator I3 Plus
29