Waters Prep Series - Getting started

1-14 Overview
RCM modules
A range of radial compression modules (RCMs) accommodates Radial-Pak™
cartridges (8 × 10 mm, 25 × 10 cm, or 40 × 10 cm) for small-scale or large-scale
operation. Radial-Pak cartridges are available in many and different
packings.
Flow splitter option
The flow splitter option modifies the Prep Series for high flow rate use with a
refractive index detector. It splits eluent flow so that 1% goes to the
refractometer and 99% to the UV detector or fraction collector. This serves the
necessary purpose of minimizing solvent pressure on the RI cell. The option
includes an RI reference flush valve.
Accessories, such as autoinjectors or detectors, are available from your Waters
sales representative.
Getting started
This section describes using the Waters Prep Series, focusing specifically on
these operations:
• Starting the system
• Using the front panel of the PrepLC controller
• Shutting down the system
• Configuring the PrepLC controller
Starting the system
If this is the first time you are starting the system, make sure all components
are properly installed.
Press the On/Off switch on the front panel of the PrepLC controller to the ON
position to start the system.
Caution: To ensure proper ventilation, operate the system with covers in
place. Failure to do so shortens the life expectancy of some parts and
invalidates the warranty.