Required tools and materials
• Chemical-resistant, powder-free gloves
• Tray on which to place the pump
• Container to catch used oil
• Suitable pump oil
Warning: To avoid personal contamination with biologically hazardous or toxic compounds,
wear clean, chemical-resistant, powder-free gloves when performing this procedure.
Warning: To avoid burn injuries, allow the pump to cool before touching surfaces
displaying the burn warning symbol.
Warning: To avoid slip injuries, inspect the pump for oil leaks.
To add oil to the backing pump:
1. Power-off the instrument using the power button in the top, left-hand corner of the front
panel.
2. Wait approximately five minutes to allow the instrument to vent.
3. Switch off the pump and disconnect the power cable.
Warning: To avoid skeletal or muscle injury associated with lifting heavy
objects, at least two persons must lift the pump.
4. Place the pump on a tray suitable for catching dripping oil.
5. Remove the oil drain plug from the pump’s rear panel.
January 10, 2022, 715006200 Ver. 01 (previously released as Rev. A)
Page 86
To Next Page
