Need help?Do you have a question about the Waters Xevo TQ-S micro and is the answer not in the manual?
General| Type | Triple Quadrupole Mass Spectrometer |
|---|---|
| Scan Speed | Up to 10, 000 Da/sec |
| Software | MassLynx |
| Polarity | Positive and Negative |
| Ionization Source | ESI, APCI, APPI |
| Mass Range | 2 to 2048 m/z |
| Scan Modes | MRM, Full Scan, Product Ion Scan, Precursor Ion Scan, Neutral Loss Scan |
Covers various hazards and safety notices for instrument operation and maintenance.
Provides contact information for technical support and general inquiries.
Defines the instrument's purpose as a research tool for quantitative analysis.
Outlines routine procedures for ensuring instrument performance and data validity.
Details the instrument's capabilities and compatible Waters ZSpray sources.
Introduces various ionization methods used with the instrument.
Introduces different Mass Spectrometry operating modes.
Outlines the procedure for powering on the workstation, instrument, and software.
Provides instructions for safely shutting down the instrument in an emergency.
Covers installing and removing an ESI probe for ESI applications.
Details APCI mode for producing singly charged molecules and its interface.
Introduces the ionKey source integrating UPLC separation.
Lists periodic maintenance tasks, frequencies, and information sources.
Outlines general safety considerations and precautions for maintenance procedures.
Covers replacing the ESI probe tip and gasket when blocked or damaged.
Explains hazard symbols alerting to risks during use or misuse.
Warns about electric shock risks and protective panels.
Warns about processing biohazards, corrosive, or toxic materials.
Required materials and steps to connect the oil-filled roughing pump.
Steps to connect the alternative oil-free roughing pump.
Required materials and steps to connect the nitrogen gas supply.
Lists items exposed to solvent and their materials for safety evaluation.
Lists common ingredients for mobile phases in reverse-phase LC/MS (API).
Describes the selector valve's location, etched letters, and port connections.
Provides specifications for replacement tubing, nuts, and ferrules.
To Next Page
