Watlow 97 series - Software Map

4.4 ■ Navigation Watlow Series 97
Navigation
Software Map
Figure 4.4 — Software Map.
[LIM] Limit Menu
[OPEr]
Operations Page
[OPEr] Operations Page
[L`Lo] Low Limit Set Point
[L`hi] High Limit Set Point
[CAL1] Calibration Offset


[OPEr] Operations Page
[Pr1`] Process 1
[L`St] Limit Status
[AL`2] Alarm 2 Status
[AL`3] Alarm 3 Status
[AL`4] Alarm 4 Status
[E`St] Event Input Status

[OPEr] Operations Page
[A2Lo] Alarm 2 Low
[A2hi] Alarm 2 High
[A3Lo] Alarm 3 Low
[A3hi] Alarm 3 High
[A4Lo] Alarm 4 Low
[A4hi] Alarm 4 High
‰
‰
‰
¿
¿
[Mon] Monitor Menu
[OPEr]



[ALM] Alarm Menu
[OPEr]
¯
¯

[``97] Process Value
[safe]








Home Page
Limit Status
[``97] Process Value
[Safe]
Limit Status

[LIM] Limit Menu
[OPEr]
Operations Page



[InP1] Input 1 Menu
[`SEt] Setup Page



[`LOC] Custom Menu
[FctY] Factory Page
Home Page
¿ and ¯
for 3 seconds
Operations Page
Setup Page
Factory Page
¿ and ¯
for 3 seconds
‰ and RESET
for 6 seconds
¿ to cycle through menus
‰ to select a parameter in a menu
¿ to select a value
‰ to enter a value and go to the next parameter
RESET anytime to return to the Home Page