Watlow 97 series - Output Calibration Menu

Watlow Series 97 Parameters ■ 6.21
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
Active if Output 4 is process (97 _
_-_ _ _ M-_ _ _ _) and
Calibration Lock (Lockout
Menu) is not set to [hide]
1622 w10.000.00 to 99.99
[4`10] Output
Calibration 4, 10V
Enter the output
value in volts as
measured.
Active if Output 4 is process (97 _
_-_ _ _ M-_ _ _ _) and
Calibration Lock (Lockout
Menu) is not set to [hide]
1621 w1.000.00 to 99.99
[4``1] Output
Calibration 4, 1V
Enter the output
value in volts as
measured.
Active if Output 4 is process (97 _
_-_ _ _ M-_ _ _ _) and
Calibration Lock (Lockout
Menu) is not set to [hide]
1620 w20.000.00 to 99.99
[4`20] Output
Calibration 4,
20mA
Enter the output
value in milliamps
as measured.
Active if Output 4 is process (97 _
_-_ _ _ M-_ _ _ _) and
Calibration Lock (Lockout
Menu) is not set to [hide]
1619 w4.000.00 to 99.99
[4``4] Output
Calibration 4,
4mA
Enter the output
value in milliamps
as measured.
[cout] Output Calibration
Menu
[Fcty] Factory Page
Factory Page / Process Output Calibration Menu